Jump to content
3DCoat Forums

Create Extension -Smart Martial Files Size limit


Ascensi
 Share

Recommended Posts

  • Contributor

Apparently maybe because I'm a new forum member I don't have access to post this problem to the "Interface, general usability and other problems" section so I'm posting my issue here.

I have a large library I created that has many 8K textures and creates a output size of 5.96 GB -the out put file only was created to export my smart materials only. I've exported smaller smart material extensions (2GB) and restored them fine but with the 5.96 GB extension size it wont install, the message just flashes the on my screen "it is recommended to exit 3D coat restart it to apply all changes". 

 

Would anyone know what the problem might be? Each of the materials work just fine at this time locating the textures as it needs them located out side of 3D coat when I created the materials.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...