Jump to content
3DCoat Forums

CMTK

Member
  • Content count

    13
  • Joined

  • Last visited

Community Reputation

1 Neutral

About CMTK

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Enable
  1. I want to make the orange screens in the reference, but I can't figure out how to make the extrude brush paint at a straight line. Any way I can do that?
  2. CMTK

    How do I sculpt this?

    Now that I figured out how to do the seven shapes on the table, I need to boolean out some of the parts off the edge of the upper level as seen on the reference. Any good way to do this?
  3. Thanks! it worked
  4. Uhh... I'm confused
  5. I'm trying to sculpt the highlighted mesh as seen in the pictures above. I used the blob tool with radial symmetry, but the result gives a mesh that is offsetted on the X axis which can't be fixed no matter what I try. Is there a better way to do it?
  6. It used to work fine in .49, but after updating to .53, it do esn't work anymore video0.mov
  7. video0 (2).mov I want to tool to snap to edges as well as vertices, but I don't know how.
  8. I’ve been asking everyone about this mystery and nobody has been able to explain how this works. I asked multiple people to try the same operation and all they got were 31 points on the bottom of the mesh placed in the same exact way no matter where on the mesh they clicked. As far as I know, the tutorial guy was the only one to have successfully done the operation and not even he has any idea what is going on. We checked everything that could go wrong and NOTHING worked! Please help. FullSizeRender.mov
  9. I checked everything that was said in the tutorial. I don't know what else I can do.
  10. So I was able to get the radial symmetry working on the tool by turning of Virtual Mirror Mode, sort of. Now the tool makes multiple points, but they are always placed at the bottom of the mesh in a very specific way no matter which side of the mesh I click on. Is there a fix for this? https://cdn.discordapp.com/attachments/680168650791321774/728034794939613194/video0.mov
  11. According to a tutorial (https://youtu.be/cNAMye3-jSE?t=283), the points/faces tool is supposed to put multiple points when radial symmetry is turned on. However, it's not the case for me (https://cdn.discordapp.com/attachments/541652288276660254/726601367560519720/video0.mov). When I use the tool with the same symmetry settings, it completely ignores the symmetry. I tried everything, but nothing fixed it. Is there a fix? (File: http://www.mediafire.com/file/2qve76c78607mek/first_project.3b/file)
×