Advanced Member FreezeFrame Posted May 21, 2014 Advanced Member Share Posted May 21, 2014 (edited) A simple Tranquilizer Gun for first hard surface in 3D Coat. Basically almost done. Still needs a couple small parts. One more night it will be ready for retopo. I have to go over every part and check that it's centered along the axis. I had a real issue with this and cost loads of time. ......................Actually I just found using symmetry at the line to ensure it is at it's Global space I guess. Hard surface a little different.....just a little! not much.... From my custom concept here. https://plus.google.com/101774691462828856815/posts/Sny2uYWSewh Edited May 21, 2014 by FreezeFrame 1 Quote Link to comment Share on other sites More sharing options...
Advanced Member FreezeFrame Posted May 22, 2014 Author Advanced Member Share Posted May 22, 2014 Very Close to be finished. Still needs fine edits and a rear sight. Leaving all bumps to the normal for low poly.I don't know but some guns a extension off the lever come off where the clip is. I think some clips are right beside it? I'm probably going to change where the red line is to a continuous smooth piece. Now how do I do this low poly!! Maybe a project in a week or two.....! Quote Link to comment Share on other sites More sharing options...
Advanced Member FreezeFrame Posted May 22, 2014 Author Advanced Member Share Posted May 22, 2014 Changed that piece really quick from the above and looks better(Obviously needs fixing around that area still after the change).....So next time I post it will be a finished high poly version. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.