Jump to content
3DCoat Forums
vivi

[Solved] PBR default specularity level

Recommended Posts

is it just me or is there always a default amount of specularity on that new preview system. even though i turn of my specular layers and apply a black color, it reflects...

Share this post


Link to post
Share on other sites

PBR will always have some reflectivity, as it would be in reality. At the lowest gloss/highest roughness that'll only be at grazing angles, unless there's a flaw in the 3DC beta.

If you're looking for the old behaviour, I'm not quite sure how you'd go about returning to that (and I do hope it's possible!)

Share this post


Link to post
Share on other sites
is it just me or is there always a default amount of specularity on that new preview system

 

About preview are you talking about the fill tool preview or new PBR system in general ?

You can try these settings :

No specular :  Gloss = 0, Metalness = 0

Some specular : Gloss = 0, Metalness = 50

Reflective surface : Gloss = 50, Metalness = 0-100

 

In fact compared ot the old system , you just replace specular by metalness keeping Gloss on ver low values if you don't want reflection

Share this post


Link to post
Share on other sites

×