Member vladius Posted September 29, 2016 Member Report Share Posted September 29, 2016 (edited) I'm now using the Absolute tool in the Average normal mode. Look what I get, when making an indent on a surface. That's a wireframe view from the side. the indent should be parallel to the outer surface but it is in some wavy pattern instead. Edited September 29, 2016 by vladius Quote Link to comment Share on other sites More sharing options...
Contributor Tony Nemo Posted September 29, 2016 Contributor Report Share Posted September 29, 2016 Perhaps you must turn off spacing in Brush Options. Quote Link to comment Share on other sites More sharing options...
Member vladius Posted September 30, 2016 Author Member Report Share Posted September 30, 2016 14 hours ago, Tony Nemo said: Perhaps you must turn off spacing in Brush Options. Nah, not the cause. In fact, it seems like you can turn it off and set a spacing of 1%, which still be better than no spacing at all) I have create a whole new special thread devoted to spacing issues: Feel free to comment and make your own tests. 1 Quote Link to comment Share on other sites More sharing options...
Contributor Tony Nemo Posted September 30, 2016 Contributor Report Share Posted September 30, 2016 Good idea to check one of 3DC's more obscure corners. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.