Jump to content
3DCoat Forums

Text and curve tool doesn't work


Recommended Posts

  • Member

Hi Carlosn thanks for your reply......I was thinking about a stupid error, simply because 3 days ago everything was ok....and I found it.

As you can see in the image above, "Invert shift action" is active, so it draws the curve only when i keep the shift pressed....shame on me.... please delete this post and thanks again for your support

Edited by StefanoCiarrocchi
  • Like 1
Link to comment
Share on other sites

  • Contributor

Using the 'End' key over the "Radius" field in the upper tool parameters (almost any other tool will show it) may allow you to create a shortcut. But the cutoff tool doesn't need a radius setting because it uses the selection rectangle or lasso to designate a part for deletion.

Use the 'E' key to see your choices.

Edited by Tony Nemo
typo
  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...