Jump to content
3DCoat Forums

Freeze/Mask from Decimation


McCabe
 Share

Recommended Posts

  • Member

Hi all, quick question... Is there a way to mask an area from the 'Geometry>Decimate' command, would be great to have a bit more control over that and allow me to be more aggressive with the Decimation.

Cheers. ^^

Link to comment
Share on other sites

  • Member

Yes, I did try that but its nice to set a target number of polys through the decimate function. But yeah would be a not bad work around.

Thanks Carloson

Edited by McCabe
Link to comment
Share on other sites

  • Member

I'd also like something like this, currently I use clean clay brush but since it depends on brush size and strokes, results vary. I've avoided decimate near edges but perhaps I use freeze tool wrong(I was freezing areas I didn't want to be affected(as freeze would imply) but if the decimate is too strong it would still affect those areas.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...