Member McCabe Posted December 15, 2017 Member Report Share Posted December 15, 2017 Hi all, quick question... Is there a way to mask an area from the 'Geometry>Decimate' command, would be great to have a bit more control over that and allow me to be more aggressive with the Decimation. Cheers. ^^ Quote Link to comment Share on other sites More sharing options...
Carlosan Posted December 15, 2017 Report Share Posted December 15, 2017 Try using Freeze + Clean Clay Quote Link to comment Share on other sites More sharing options...
Member McCabe Posted December 15, 2017 Author Member Report Share Posted December 15, 2017 (edited) Yes, I did try that but its nice to set a target number of polys through the decimate function. But yeah would be a not bad work around. Thanks Carloson Edited December 15, 2017 by McCabe Quote Link to comment Share on other sites More sharing options...
Member kwhali Posted December 15, 2017 Member Report Share Posted December 15, 2017 I'd also like something like this, currently I use clean clay brush but since it depends on brush size and strokes, results vary. I've avoided decimate near edges but perhaps I use freeze tool wrong(I was freezing areas I didn't want to be affected(as freeze would imply) but if the decimate is too strong it would still affect those areas. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.