Jump to content
3DCoat Forums

Identify holes in surface?


kwhali
 Share

Recommended Posts

  • Member

When running the Geometry menu and choosing close holes, the popup is aware of 50+ holes. I ask it to close them, some tiny holes that were not easy to spot such as single triangle become large, however, hole fill appears to have failed.

Can I some how highlight the holes instead or cycle through them with camera aligning to the hole with previous and next buttons to navigate?

As it is surface, the mesh have some areas that might be considered a hole but is not, eg window or door cavity with no thickness . Perhaps this causes the failure. I could manually repair actual holes if coat could show me where they are.

Link to comment
Share on other sites

  • Reputable Contributor

Yesterday I  posted about this subject in the Beta forums. Feel free to add your own comments. A validation checking routine of the mesh and marking of the error areas like Mudbox would be very helpful to the end user. A must for Autopo to function correctly.

Edited by digman
  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...