Member TallBhoy Posted March 2, 2018 Member Share Posted March 2, 2018 (edited) Hey, Currently in the process of unwrapping a model. I'm trying to use the copy and paste uv tools to overlay some uv tiles that I want repeated. See below. However when I attempt to copy paste them nothing is happening despite them being completely identical? This isn't the only uvs its happening too, it's the same with all other identical uvs.I've also had this happen on older files too. Below is a pic of the object in mention. I'm running the latest version. Any help would be greatly appreciated. Thanks. Edited March 2, 2018 by TallBhoy Quote Link to comment Share on other sites More sharing options...
Carlosan Posted March 2, 2018 Share Posted March 2, 2018 Hi Are you using latest version 4.8.11, following this steps and is not working ? * I am asking this because Is working fine from my side. Quote Link to comment Share on other sites More sharing options...
Member TallBhoy Posted March 2, 2018 Author Member Share Posted March 2, 2018 Was on 4.8.10, updated to 4.8.11, still happens sadly. Has been an issue I've encountered on a few versions now. I Crtl+C then Ctrl+V and nothing happens, same goes for pressing the buttons manually. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted March 2, 2018 Share Posted March 2, 2018 Could you please share the model to take a look ? Quote Link to comment Share on other sites More sharing options...
Member TallBhoy Posted March 2, 2018 Author Member Share Posted March 2, 2018 (edited) Sure I PM'd you a link to a gdrive folder. It has the original blender file and the 3D-Coat file. I've just got the rest of the gun automapped for now but the long magazine is unwrapped the way shown in the picture Edited March 2, 2018 by TallBhoy Quote Link to comment Share on other sites More sharing options...
Carlosan Posted March 2, 2018 Share Posted March 2, 2018 Yes you are right, copy/paste is not working with this project. I only exported the UV as obj and imported it again in a new fresh project. I think is working fine now. Can you please test it ? *check PM. Thx //edit Bug reported 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.