Advanced Member Dmitry Bedrik Posted May 9, 2018 Advanced Member Share Posted May 9, 2018 Can I change the direction of the spline to be used in conjunction with the "brush along the curve"? Because of the bug, the created mesh does not reach the end of the curve on one side, but draw a curve so that the mesh reaches the right place, idiocy. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted May 9, 2018 Share Posted May 9, 2018 This issue was reported and the request is OPEN. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.