Advanced Member Dmitry Bedrik Posted January 15, 2019 Advanced Member Report Share Posted January 15, 2019 I thought that in drawing mode "Stroke Curve" any tool would act directly below the line. However, it is not. For some reason, the impact is shifted relative to the line. Either the tool is buggy, or it initially does not work the way most normal users understand it. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted January 16, 2019 Report Share Posted January 16, 2019 Pinch default value is 100%, are you using 0% for any reason ? Quote Link to comment Share on other sites More sharing options...
Advanced Member Dmitry Bedrik Posted January 16, 2019 Author Advanced Member Report Share Posted January 16, 2019 It is absolutely not about interest. Try it yourself, how this drawing mode works, and you will understand. Quote Link to comment Share on other sites More sharing options...
Advanced Member Falconius Posted January 16, 2019 Advanced Member Report Share Posted January 16, 2019 (edited) It's a perspective issue. The mesh is altered not from your veiwport but directly under where the stroke occurs on the surface of the mesh. Edited January 16, 2019 by Falconius Quote Link to comment Share on other sites More sharing options...
Advanced Member Dmitry Bedrik Posted January 16, 2019 Author Advanced Member Report Share Posted January 16, 2019 6 minutes ago, Falconius said: It's a perspective issue. The mesh is altered not from your veiwport but directly under where the stroke occurs on the surface of the mesh. In any case, it works incorrectly and completely illogical. Quote Link to comment Share on other sites More sharing options...
Advanced Member Falconius Posted January 16, 2019 Advanced Member Report Share Posted January 16, 2019 I disagree, seems logical for it to alter the mesh where the line falls on the mesh, and indeed if you wrapped it around the mesh in 3d space it would still work. If it just popped up directly towards the view port not only would that cause problems any time you used it in non-orthographic mode, but it wouldn't work for any lines defined in 3d space. There are plenty of nice tools that do things based on the view port, perhaps try one of them instead? Quote Link to comment Share on other sites More sharing options...
Advanced Member Dmitry Bedrik Posted January 16, 2019 Author Advanced Member Report Share Posted January 16, 2019 It seems that you do not understand the essence of my post. Instead of performing the operation in the same way as the "Brush along the Curve" or "Vertex Lines" option, the result of the operation appears somewhere off the "Curve Stroke". Quote Link to comment Share on other sites More sharing options...
Advanced Member Dmitry Bedrik Posted January 16, 2019 Author Advanced Member Report Share Posted January 16, 2019 (edited) Version .20. Edited January 16, 2019 by Dmitry Bedrik Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.