Advanced Member Innovine Posted August 7, 2019 Advanced Member Report Share Posted August 7, 2019 what is meant by soft booleans and how can I test this and see what it is? Quote Link to comment Share on other sites More sharing options...
Featured Comment Carlosan Posted August 7, 2019 Featured Comment Report Share Posted August 7, 2019 On 6/15/2019 at 11:43 AM, co3Darts said: In sculpt room, build a sphere primitive. Then make sure it's in surface mode. Build a box primitive on same layer, under tool options set mode to add, sub, intersect etc. and a gray box next to it should be there. Click on gray box and apply soft boolean option which allows the intersection edge to be filleted, chamfered when apply button is pressed. Quote Link to comment Share on other sites More sharing options...
Advanced Member Innovine Posted August 7, 2019 Author Advanced Member Report Share Posted August 7, 2019 I'll check it out, thanks. Quote Link to comment Share on other sites More sharing options...
Member MorganNilsson Posted January 15, 2020 Member Report Share Posted January 15, 2020 Will this come to voxel mode as well? (Would be super awesome) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Posted by Carlosan,
Recommended by Carlosan0 reactions
Go to this post
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.