Jump to content
3DCoat Forums

Problem with the closed spline tool


Recommended Posts

  • New Member

I'm trying to make a cut in my model using the closed spline, but for some reason it only works randomly.

Before.thumb.jpg.56a724a6bc0cddef240824b2607ceb51.jpg

After I pressed enter:

After.thumb.jpg.5c4dfdc04c2723b257f31c8c9b59d691.jpg

Sometimes it works just fine, usually when I just close the spline without making changes. But most times it just ignores or make these wrong cuts.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...