Member Badger Posted December 25, 2020 Member Report Share Posted December 25, 2020 Hi, just started using 3d coat and was wondering if it was normal to have these ins and outs when pulling out geometry with the pose tool. Also sometimes the rectangle lasso for the pose tool makes a weird selection where when ignore back faces is off it doesn't line up properly with the other side and when making a selection the lassoed area enlarges from what I wanted to select. Any help with these problems would be much appreciated. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted December 25, 2020 Report Share Posted December 25, 2020 Hi Yes is normal when you work on voxel mode. It appears to me that your voxel object is low resolution. You simply do not have enough voxel resolution to create clean cut. Increase the voxel resolution. Left tool panel. (Res+) or use Resample. A voxel represents a value on a regular grid in three-dimensional space. Is a volumetric pixel. But to have definition either the model must be huge or the grid must be very dense. That makes fine detail modeling very expensive. Projects easily weigh huge over 1M polys. Use the voxels to sketch the general shapes, and switch to surface mode to add details. The finer details can be accomplished with LiveClay mode. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted December 25, 2020 Report Share Posted December 25, 2020 Quote Link to comment Share on other sites More sharing options...
Member Badger Posted December 25, 2020 Author Member Report Share Posted December 25, 2020 Thanks for the info Carlosan. Do you know anything about the expanding red selection area when trying to make a selection with the rectangle lasso in the pose tool? Quote Link to comment Share on other sites More sharing options...
Carlosan Posted December 26, 2020 Report Share Posted December 26, 2020 Pose Fall off ? Can be edited changing Stroke BorderWidth or Pose Fall Off Quote Link to comment Share on other sites More sharing options...
Member Badger Posted December 26, 2020 Author Member Report Share Posted December 26, 2020 I played around with those but it was the same, I was watching a tutorial and it looked like he was having the same problem. The red selection becomes bigger than the actual selection marquee as if it was snapping to something. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted December 28, 2020 Report Share Posted December 28, 2020 https://discord.com/channels/680168650791321648/680168650791321774/793045821137879051 Sillas Merlin said: It seems to me that what you are trying to do for falloff should look more like this ? when you move the points together they should merge, but to make sure they did, you need to move the point around (to see if there are still two) also, try right click layer > to global space before you pose ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.