Jump to content
3DCoat Forums
Sign in to follow this  

[BUG] Crash when Retopo mesh -> Sculpt Room

Recommended Posts

.72 version - Crush when Retopo mesh -> Sculpt Room. 

The .65 version was the same. In the intermediate, most likely the same. After all, wouldn't it be easier to send the selected mesh layer FROM the retopology room to the selected layer in the sculpting room? Despite the fact that these panels are located NEARBY. Because in the sculpting room, pulling a file, begging for it, from the retopology room is simply illogical.

Share this post

Link to post
Share on other sites

Try removing any nGon before send the selected mesh from Retopo to Sculpt room.

Hope it help


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this