Jump to content
3DCoat Forums

The enter key does not apply brush stroke in 2021


polynut
 Share

Go to solution Solved by polynut,

Recommended Posts

  • Advanced Member

Hi guy's, just using the trial of 2021 and i notice the enter key does not apply the brush stroke anymore, instead it open the voxel dialog. So my question is how can i apply my stencil with a key stroke like before? I don't want to brush it over since it is not giving a good result.

Link to comment
Share on other sites

  • Member
Carlosan
This post was recognized by Carlosan!

houGenie2 was awarded the badge 'Helpful' and 1 points.

1 hour ago, Yousung said:

2097027013_bandicam2021-12-2902-51-16-129.thumb.jpg.a3ef0961eba3a03703effebe17e700e7.jpg

1.Select the curve you want to stroke
2.Press Q and select any tool. The Cuve editor will become active.
3. Press Enter
4. The brush will be stroked along the curve

Enter key works for me in version 83. As a workaround you can select the curve in the curve tree window and apply it.

Link to comment
Share on other sites

  • Advanced Member

Hi guy's thank for the replies but i am not talking about curve but the regular brush but i was mistaken when i said it was working in 4.8.72 it is the same as in 2021. Maybe this was working in an earlier version but i am not sure about it.

Edited by polynut
Link to comment
Share on other sites

  • Member
On 12/27/2021 at 11:24 PM, polynut said:

Hi guy's, just using the trial of 2021 and i notice the enter key does not apply the brush stroke anymore, instead it open the voxel dialog. So my question is how can i apply my stencil with a key stroke like before? I don't want to brush it over since it is not giving a good result.

Are you talking about surface mode or in voxel mode? When you are in the voxel mode and you use a surface brush, then you can apply the change (this means voxelization) with enter.

Link to comment
Share on other sites

  • Advanced Member
  • Solution
3 hours ago, houGenie2 said:

Are you talking about surface mode or in voxel mode? When you are in the voxel mode and you use a surface brush, then you can apply the change (this means voxelization) with enter.

I was talking about surface mode but i finally figure it out, the rectangle stroke did the trick but now i am trying to figure which brush is the best to use to apply the height map. Also i need to figure the grey color i need for the background of the height map so it equal 0 in 3d coat.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...