Member Norris Lin Posted September 28 Member Share Posted September 28 (edited) I have purchased some trim patterns from artstation and imported them into 3Dcoat as Strips. When I draw with buildup tool, it created gap along the stroke and I can't make it seamless even though the 2D images are perfectly seamless. I tried tweaked all the setting possible and reduce the spacing to a low number but nothing help. I am assuming this is a new bug happen when importing, it used to be fine, not sue which version messed this up. Edited September 28 by Norris Lin 1 Quote Link to comment Share on other sites More sharing options...
Carlosan Posted October 1 Share Posted October 1 I applied the strip with the brush settings at default and did not find any errors Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.