Member calilifestyle Posted December 7, 2024 Member Share Posted December 7, 2024 Hi Everyone, It has been some time since I asked a question. So, I guess I'm struggling to figure out how to use the 3d print module. Is there any NEW training on how to use it? I don't know how to set it for FDM or resin. Up filament types. Or set up a slice. Are there any 3rd party add-ons? Is there a way to send out the code? Quote Link to comment Share on other sites More sharing options...
Carlosan Posted December 8, 2024 Share Posted December 8, 2024 There is a quick start playlist For specific question please contact support@3dcoat.com Quote Link to comment Share on other sites More sharing options...
Member calilifestyle Posted December 11, 2024 Author Member Share Posted December 11, 2024 (edited) Thank you Carloson, Yeah I've seen few of these at lest the last part of. The 1st part few videos are just how to use 3dcoat. I was hoping there was a but more information on how to set it up. Maybe some integration with orcaslicer. Maybe few options on slicing with supports. Maybe a simulate heat bed print. I was playing with lychee slicer for FDM and immediately thought of 3dcoat as another solution. The Lychee slicer for FDM is base of of Octoprint (sorry i think and may be wrong) thank you again Edited December 11, 2024 by calilifestyle Quote Link to comment Share on other sites More sharing options...
Oleg Shapov Posted December 11, 2024 Share Posted December 11, 2024 8 hours ago, calilifestyle said: I was playing with lychee slicer for FDM and immediately thought of 3dcoat as another solution. Hello! 3Dcoatprint is intended only for creating a model and preparing it for work with a slicer. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.