D.R. Greenlaw
-
Posts
69 -
Joined
-
Last visited
Community Answers
-
D.R. Greenlaw's post in [Solved] Module4 Error was marked as the answer
Here's what fixed the issue: I found that 3D Coat stores user configs, crash logs, etc., in the User Documents folder. I don't normally use the Documents folder and I didn't immediately think to check there. Actually I found multiple 3D Coat folders there going back for many years in, and after I deleted them, I'm no longer seeing that Module4 error after installing 3D Coat and opening the Sculpt room. (As expected, I did have to reactivate the license.)
So, if you experience any really weird issues/behaviors that nobody else seems to be having, this is a potential fix.
Ok, next problem...
-
D.R. Greenlaw's post in [Solved] Module4 Error was marked as the answer
Ok, completely removing 3DCoat and performing a clean install seemed to fix this issue. Just responding to my own thread in case somebody else runs into this.
Now I can get back to figuring out my original problem.
-
D.R. Greenlaw's post in Add points to autopo stroke? was marked as the answer
Ah! I think I figured it out. I have to break the closed spline where I want to add the point(s) and extend one of the open ends, then I can close it again.
I wish I could simply click on the spline while holding a key to add the point--that would be much easier.