Try deleting points

Thanks, the problem is it's a free floating edge and I cannot seem to select it. The black line below the Polygons.

You can delete edges primarily in the Retopo Room using the Tweak tools, specifically the Delete Edges tool or the Add/Split tool, where holding Ctrl deletes entire edge loops, while a single click deletes single edges, allowing for quick topology cleanup or reduction, often combined with tools like Collapse or Slide Edges.  This video demonstrates how to delete edges and edge loops in 3DCoat:  

Is there a way to clean up or delete lose edges? Especially if they cannot be selected? Thanks

I see your point, but it wasn't working like that this morning. Now I was checking with a very simple cylinder and it works. I'll let you know. Thank you.

This model is very tiny ? May be inner and outer cage (on Bake settings) are collapsing ?

The Bridge tool adds new faces to the active group.

Hello, I've just bridged two open edge loops in the same polygroups (green part to red one to have the pink), but when I hide that polygroup, the created polygons are in a sort of limbo, they are not part of that polygroup, I have to put them manually in the polygroup. Can it be fixed? Thank you.

Help needed! I used Bake with Normal Map in the Retopo Room, but after the baking process finished, I noticed in the Painting Room that the resulting normal map is completely broken. Additionally, after running Calculate Occlusion, some parts of the model turned black. I’m not sure whether this issue is caused by problems with the model itself, or if I made mistakes during certain steps of the workflow. The high-poly model was fully sculpted in 3DCoat. The low-poly model was generated by exporting the high-poly mesh to another software for automatic retopology, then slightly edited in Blender, and finally re-imported back into 3DCoat. I initially tried using 3DCoat’s built-in AutoPO, but the topology quality was not satisfactory, which is why I switched to a different retopology solution. Before this bake, I had already successfully used Bake with Normal Map on two other models without any issues. This problem only occurred on the third model. Because my .3b file is too large to upload, I will instead provide relevant screenshots to help illustrate the issue.

Hello! I've run into an issue, when I use clone tool, I'm not able to select cloned volume by using quick pick tool. It works fine with new volumes made by using Split tool so it seems like a bug? See gif below     Solved this myself, there's this cheeky parameter I needed to toggle on

Great, thank you!

Try this option Hope it help

Is there a way to to select or mask faces by the the crease angle? That would be useful to separate distinct surfaces of a mesh, especially from 3D scans where the topology is random. Thanks!

Hello, I just switched distributions to pikaos(kde) on the Debian family. I am writing to inform you of two errors: ** (3dcoat:179086): WARNING **: 14:53:49.445: (../atk-adaptor/bridge.c:1086):atk_bridge_adaptor_init: runtime check failed: (root) (3dcoat:179086): Gtk-WARNING **: 14:53:49.578: Unable to find theme engine in module_path: “adwaita” I will test it more thoroughly later. Have a nice day.

Can't do, not with this one, but I'll let you know when that happen next time.

3DCoat Low-Poly Modeling for Beginners #45. Dinosaur. Part 21View the full article