source... Friction is a powerful, lightweight and cross-platform open-source 2D animation package, similar to Adobe Animate or After Effects. Friction is a fork of the now abandoned ENVE project(learn more) that is rapidly approaching the 1.0 milestone release. It has come a long way since being forked from ENVE and is showing a heck of a lot of promise.    

The model have uDims ? If yes, try this workflow  

感谢您的回复。 我后来尝试了一些其他方法，看来问题可能与烘焙多个网格有关。 每当我尝试烘焙第三个网格时，问题就会出现在这个网格上。但是，如果我删除前两个已经烘焙好的网格，第三个网格就可以正常烘焙，没有任何问题。

Hi Use Vox Layer Tool, it will help

Hello everyone, I am a new 3D Coat user and unfortunately I have a big problem. I looked for a solution in some forum threads, but I couldn’t find exactly what I was looking for. I can’t find the Mask Extract or Freeze Extract function. I want to extract the masked area as a separate mesh. Could you please help me? Thanks a lot.

Try deleting points

Thanks, the problem is it's a free floating edge and I cannot seem to select it. The black line below the Polygons.

You can delete edges primarily in the Retopo Room using the Tweak tools, specifically the Delete Edges tool or the Add/Split tool, where holding Ctrl deletes entire edge loops, while a single click deletes single edges, allowing for quick topology cleanup or reduction, often combined with tools like Collapse or Slide Edges.  This video demonstrates how to delete edges and edge loops in 3DCoat:  

Is there a way to clean up or delete lose edges? Especially if they cannot be selected? Thanks

I see your point, but it wasn't working like that this morning. Now I was checking with a very simple cylinder and it works. I'll let you know. Thank you.

This model is very tiny ? May be inner and outer cage (on Bake settings) are collapsing ?

The Bridge tool adds new faces to the active group.

Hello, I've just bridged two open edge loops in the same polygroups (green part to red one to have the pink), but when I hide that polygroup, the created polygons are in a sort of limbo, they are not part of that polygroup, I have to put them manually in the polygroup. Can it be fixed? Thank you.

Help needed! I used Bake with Normal Map in the Retopo Room, but after the baking process finished, I noticed in the Painting Room that the resulting normal map is completely broken. Additionally, after running Calculate Occlusion, some parts of the model turned black. I’m not sure whether this issue is caused by problems with the model itself, or if I made mistakes during certain steps of the workflow. The high-poly model was fully sculpted in 3DCoat. The low-poly model was generated by exporting the high-poly mesh to another software for automatic retopology, then slightly edited in Blender, and finally re-imported back into 3DCoat. I initially tried using 3DCoat’s built-in AutoPO, but the topology quality was not satisfactory, which is why I switched to a different retopology solution. Before this bake, I had already successfully used Bake with Normal Map on two other models without any issues. This problem only occurred on the third model. Because my .3b file is too large to upload, I will instead provide relevant screenshots to help illustrate the issue.

Hello! I've run into an issue, when I use clone tool, I'm not able to select cloned volume by using quick pick tool. It works fine with new volumes made by using Split tool so it seems like a bug? See gif below     Solved this myself, there's this cheeky parameter I needed to toggle on

Great, thank you!