Plane defined by points - make us define 3 points by using one hotkey

[3DCoatUser5566]

I hope I can define the point #1 ~ #3 by using only one hotkey.
Basically, I hope I only have to press one button to define all 3 points by clicking 3 times after pressing the hotkey.
Press the hotkey, then define #1, then #2, then #3.

Currently it's too slow, and I cannot set the hotkey for red#1 green#2 blue#3 button.
Because of bugs, if I try to put a hotkey for #2 or #3, It will change all #1~#3's hotkey to the same key, and at the end, I can only pick the point for red#1.

Also, I hope there is an option to change the size of the red, green and blue point's visuals after placing them on model, for me it's too small so it's very hard to pick and change their position with right click.

 

Edited September 22, 2023 by 3DCoatUser5566
added more requests

[Oleg Shapov]

On 9/22/2023 at 9:33 AM, 3DCoatUser5566 said:

I hope I can define the point #1 ~ #3 by using only one hotkey.

Use the Stack Key to assign points with one key.

[3DCoatUser5566]

Hi, no matter which point's hotkey I change, the three points will still have the same hotkey, and pressing that hotkey can only define for point #1 (red).
I can't even set seperate hotkey for each points, let alone stack them.

 

[Oleg Shapov]

5 hours ago, 3DCoatUser5566 said:

the three points will still have the same hotkey

That's right, assign the same hotkey for all points. Each time you press the hot button, you can set the plane point.

ScreenCaptureProject967.mkv

[3DCoatUser5566]

Hi, thank you for your patience, I already understand your explaination. I did the exact same thing and it didn't work,

After I change the hotkey for all three of the points again (Redefine for red#1, stack key for green#2, stack key for blue#3) :
1. press that hotkey (let's say its "F"): I can define the red#1 point ->
2. press F the second time: define red#1 point again... ->
3. press F the third time: define red#1 point again...

But somehow, if I stack one more action/ tool on top of that hotkey( for example: "Hide plane preview" ), it will work just fine like in your video.
however, if I remove that last stacked action/ tool, it will stop working again, and then go back to "only able to define red#1 point".
It's so weird...

[Oleg Shapov]

13 hours ago, 3DCoatUser5566 said:

It's so weird...

Strange. I put an "F" on all three dots and it works great. All I can advise is to reset the default hotkeys and reassign them again.