Jump to content
3DCoat Forums
  • 0

Retopo Room polycount


Sui
 Share

Question

  • Advanced Member

Is it possible to show the polycount before autopo? I need to, most of the time, autopo and decrease the count by a certain ratio. It will be helpful if I can see the polycount of the sculpt object just like in Sculpt Room. Right now I can only see the count of the retopoed mesh after I finished autopo.

Link to comment
Share on other sites

5 answers to this question

Recommended Posts

  • 0
  • Advanced Member

No. If I am not mistaken, this is the poly count I want the mesh to have after retopo. What I want is the poly count of the sculpt objects as they are in Sculpt Room, to be shown in Retopo Room. 

For example, I want to autopo an object and reduce its poly count to one fifty. I need to go back to sculpt Room to check its current count and then set the Required Poly Count. If I could see the original number in Retopo Room, I would not need to switch between two rooms, because normally I need to work with a large number of objects.

Link to comment
Share on other sites

  • 0
  • Advanced Member
On 4/21/2024 at 11:34 PM, Oleg Shapov said:

Try using this.

image.png

Is it possible to show at least one digit after the decimal point. It becomes unclear when the count reaches a million.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...