Retopo Room polycount

[Sui]

Is it possible to show the polycount before autopo? I need to, most of the time, autopo and decrease the count by a certain ratio. It will be helpful if I can see the polycount of the sculpt object just like in Sculpt Room. Right now I can only see the count of the retopoed mesh after I finished autopo.

[Oleg Shapov]

32 minutes ago, Sui said:

What I want is the poly count of the sculpt objects as they are in Sculpt Room, to be shown in Retopo Room. 

Try using this.

[Oleg Shapov]

2 hours ago, Sui said:

Is it possible to show the polycount before autopo?

As I understand it, we are not talking about this parameter that you specify before the autoretopo?

[Sui]

No. If I am not mistaken, this is the poly count I want the mesh to have after retopo. What I want is the poly count of the sculpt objects as they are in Sculpt Room, to be shown in Retopo Room. 

For example, I want to autopo an object and reduce its poly count to one fifty. I need to go back to sculpt Room to check its current count and then set the Required Poly Count. If I could see the original number in Retopo Room, I would not need to switch between two rooms, because normally I need to work with a large number of objects.

[Sui]

Many Thx.

[Sui]

On 4/21/2024 at 11:34 PM, Oleg Shapov said:

Try using this.

Is it possible to show at least one digit after the decimal point. It becomes unclear when the count reaches a million.