smer0315

Hello, thanks for your reply I only noticed after reading your reply. It turned out to be a custom hotkey. I thought it was a preset hotkey, so I was always confused. Sorry for my bad English, because there is no set action in the film, I didn't notice it. After listening carefully for a few times, it seemed to be said in the conversation. I hope that the software can get better and better in the future.

I have a question I watched the youtubeg video tutorial and used hotkeys. But I actually used it but it didn't work, or it was replaced by another function, so has the hotkey changed or is it invalid? https://youtu.be/MjcCEx5Y0wY?t=198 There is a Reduce hotkey at 3:18, but my use of the z key is currently replaced by the z-axis movement. And the hotkey to increase or decrease the number of segments is also invalid, I am currently using 2021.15 I have always hoped that 3d coat can become my long-term software and can enter my work pipeline, so I always have purchase support, but in terms of the status quo: 1. The new version has too little teaching and the update speed is also very slow. I think you can find some suitable creators to cooperate and publish, so that new users can learn quickly and expand users. In my experience, most of the tutorials are very old or fragments, so my learning is very fragmented. I am not very familiar with some functions so far, so currently 3d coat can only be used in my amateur occasional software. 2. There is no applink. I think applink is very important. You can quickly switch to the required software, but the new website page does not have any software corresponding applink, which makes it inconvenient to incorporate it into the work pipeline. If I continue this state in the long run, it’s really hard for me to have the confidence to continue to support it, but I still hope that this software can be better.

Why is the end of the brush always not sharp, unlike Photishop, is there any setting that can be done? Is it possible to customize the sharpness of the brush Like photoshop?

Thanks your reply I will send letter.

Is there any improvement plan for the layer mask in the future? Because I always feel that the current masking method is more troublesome, and the number of layers will increase And unlike other software, you can visually observe and draw the grayscale map The following is the current method

Thanks for reply Yes, I know about the function of Additional Extrusion, I am talking about center offset when symmetrical oh~live smooth can use in retopo room great!!

Sorry, I just thought of two more requests. 1. I want to be able to set the distance between the retopo model and the reference object, because my current work is after retopo, the model needs to be turbosmooth again, and after that the model will be slightly reduced because of this, so usually I will make the model Go out a bit. I sometimes use the Additonal Extrusion in the 3d coat, but when it is previewed symmetrically, the center will also be offset. And the position when selected is still at the 0 position. 2. Hope to have a subdivision preview, like maya press the number key to have a subdivision preview. And the number of stages can be customized. I know that 3d coat 2021 will have a smooth preview in modeling room, but I’m not sure that it can also be used in the retopo room?

I have been using 3d coat for topology for several years, and I recently felt that I need a feature, which is to display open edges. I am not sure if this function is not available, but it is very convenient to check if there are overlapping points and there are no soldered points. In fact, I have encountered this problem recently. I used to export to 3ds Max and use its xnview to check, but if 3d coat has this function, I don’t need to check it in another software.

Is there a way to enter Accurate values the rotation of the environment Map? I want to see the same object results on 3d caot and substance But I do not know how the two software environment map to the same angle,precise Is there any way i can do it?