Member Kelley Posted November 17, 2013 Member Report Share Posted November 17, 2013 I've sculpted myself into a bit of a corner and I need to duplicate (already done) and flip on the X-axis to get the second leg, but I can't find a UI command for it. Quote Link to comment Share on other sites More sharing options...
Reputable Contributor AbnRanger Posted November 17, 2013 Reputable Contributor Report Share Posted November 17, 2013 I've sculpted myself into a bit of a corner and I need to duplicate (already done) and flip on the X-axis to get the second leg, but I can't find a UI command for it. Try the INSTANCER tool > (in the Tool Options Panel) New Mirror X. Quote Link to comment Share on other sites More sharing options...
Member Kelley Posted November 18, 2013 Author Member Report Share Posted November 18, 2013 (edited) The INSTANCER worked fine. I had a long bout with trying to reduce the two halves into one layer. So far I've found the best way to reduce layers is the 'Move to...', but when I get it down to two layers, and try to move #2 onto the Root layer, everything disappears: all of the model on screen, and all layers. CTRL_Z will not restore. So I close out, don't save, and re-open. This morning, I did a 'Move to...' with only the instanced layer onto it's original. Now, at least, I have both halves on one layer and I can start smoothing. Is there any need to delete/Move the (now) un-used layers? Edited November 18, 2013 by Kelley Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.