Member Kim Jong OOF Posted August 10, 2020 Member Report Share Posted August 10, 2020 There is a total of 7 separate parts on this small scaled lay er with very tiny details. They are tilted and have extrusions. Autoretopo didn't work on them. Any way I should retopo this? Quote Link to comment Share on other sites More sharing options...
Carlosan Posted August 10, 2020 Report Share Posted August 10, 2020 If autoretopo is not too bad, you finalize it by hand. If it's very rarely perfect you need to finish all by hand. Quote Link to comment Share on other sites More sharing options...
Member Kim Jong OOF Posted August 10, 2020 Author Member Report Share Posted August 10, 2020 4 hours ago, Carlosan said: If autoretopo is not too bad, you finalize it by hand. If it's very rarely perfect you need to finish all by hand. Autoretopo takes half an hour to do 7% of progress. Which means it will take over 7 hours to complete this layer without being sure if it will work or not. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted August 10, 2020 Report Share Posted August 10, 2020 So you need to finish all by hand. Or to use another algorithm as Instant Meshes Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.