I'm trying to create the look of worn edges with smart materials, but sometimes I run into a problem where the worn edges don't show up where I want them to, worn edges on flat places, and not on sharp edges where I would like. Can this be fixed? I use Less On Convex here.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
voxinbain
Hello!
I'm trying to create the look of worn edges with smart materials, but sometimes I run into a problem where the worn edges don't show up where I want them to, worn edges on flat places, and not on sharp edges where I would like. Can this be fixed? I use Less On Convex here.
Thank you!
Edited by voxinbain
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.