Member Sub-Zero Posted September 27, 2015 Member Report Share Posted September 27, 2015 1. How to draw a straight 45/90-deg line? Holding shift isn't working, as in other software. 2. How to draw a ring around cylindrical model? I tried to draw a spline around the cylinder to extrude along, but i can't do it evenly (it's higher or lower in some places). Quote Link to comment Share on other sites More sharing options...
PolyHertz Posted October 1, 2015 Report Share Posted October 1, 2015 1. View > show 2D grid (with 'snap to 2D grid enabled). Rotate the grid with the menu that pops up to get different angles, or hold shift while rotating to get angles in multiples of 22.5. Quote Link to comment Share on other sites More sharing options...
Reputable Contributor AbnRanger Posted October 7, 2015 Reputable Contributor Report Share Posted October 7, 2015 There is also the line draw mode in the E-Panel, and the Spline Stroke can draw/sculpt straight lines too. The 2nd question could be done by going to Orthographic mode > side view > in the E-Panel uncheck "Ignore Backfaces." when you try to draw a ring with something like the rectangle draw mode, it will go all the way through the model Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.