Jump to content
3DCoat Forums
McCabe

Freeze/Mask from Decimation

Recommended Posts

Hi all, quick question... Is there a way to mask an area from the 'Geometry>Decimate' command, would be great to have a bit more control over that and allow me to be more aggressive with the Decimation.

Cheers. ^^

Share this post


Link to post
Share on other sites

Yes, I did try that but its nice to set a target number of polys through the decimate function. But yeah would be a not bad work around.

Thanks Carloson

Edited by McCabe

Share this post


Link to post
Share on other sites

I'd also like something like this, currently I use clean clay brush but since it depends on brush size and strokes, results vary. I've avoided decimate near edges but perhaps I use freeze tool wrong(I was freezing areas I didn't want to be affected(as freeze would imply) but if the decimate is too strong it would still affect those areas.

Share this post


Link to post
Share on other sites

×