Member Tiles Posted May 6, 2014 Member Report Share Posted May 6, 2014 I cannot figure out how to setup the brush to paint in the way i want. In one moment it paints like crazy, then i touch something, and after that i cannot paint anything anymore. At the moment it paints just very very thin, with nearly no power. No matter how i adjust the settings, which can be found above the space. Like in this shot here. Why doesn't it paint nearly anything with these settings? I have enough radius, i have enough pressure. And how do i tell it not to paint so round? But more flat? In short, could somebody help me with how to setup a brush for painting so that it sculpts in the way that i want? Quote Link to comment Share on other sites More sharing options...
Carlosan Posted May 10, 2014 Report Share Posted May 10, 2014 Is same post related to about AbnRanger solution? Layer was in ghost mode ? Quote Link to comment Share on other sites More sharing options...
Contributor Malo Posted May 10, 2014 Contributor Report Share Posted May 10, 2014 You could paint in the paint room. But be sure for that, painting is only possible in surface mode. Switching back to voxel could causes problems. Quote Link to comment Share on other sites More sharing options...
Member Tiles Posted May 10, 2014 Author Member Report Share Posted May 10, 2014 No, it is not connected to the ghost mode problem. That was another issue. I am simply lost how to setup the brush to sculpt in the way i want. I am again and again trapped by a pencil that doesn't want to sculpt anything. Not knowing what slider to change that it paints again. What slider do i need to change that in the upper screenshot the pencil paints again? It does nearly nothing at the moment. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted May 10, 2014 Report Share Posted May 10, 2014 try falloff = 0% Quote Link to comment Share on other sites More sharing options...
Contributor Malo Posted May 10, 2014 Contributor Report Share Posted May 10, 2014 (edited) Maybe your brush radius of 0.29 is to small for your density? Edited May 10, 2014 by Malo Quote Link to comment Share on other sites More sharing options...
Member Tiles Posted May 11, 2014 Author Member Report Share Posted May 11, 2014 try falloff = 0% Thanks carlosan, that seemed to be the issue here. So much sliders ^^ Quote Link to comment Share on other sites More sharing options...
Carlosan Posted May 11, 2014 Report Share Posted May 11, 2014 There is an option in preferences to hide this sliders if you dont need its -focal shift and fall off- Quote Link to comment Share on other sites More sharing options...
Member Tiles Posted May 12, 2014 Author Member Report Share Posted May 12, 2014 Thanks for this hint Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.