Sculpting/Curves Tool branches are always hard

[Valiska]

In the Sculpting Room, the Curve Tool can smooth/harden the original curve at the red balls with a right click, or a click on the Hardness button in the tool panel. But all curves extruded from the original curve as a branch, are always hard at all the joints, and neither a right click nor a click on the Hardness button will change them.

[Elemeno]

i can replicate but its like 9/10 times it works ... and the one time it will close the spline .

[Oleg Shapov]

24 minutes ago, Valiska said:

But all curves extruded from the original curve as a branch

In version 23.16 I can not repeat this.

[Valiska]

I'm on 2023.16. Once it did smooth for me, but most of the time the branch joints stay hard.

[Carlosan]

Do you have Sharp segments turned OFF ?

[Valiska]

And today I can't reproduce it either. 

I have Sharp Segments turned off now. So far as I know I had it turned off before too, because I never changed the settings.

I'm not sure what's going on here. If it never comes back, I don't have a problem.

Thanks.