Commands for Sculpt room

There are only a small number of commands in the sidebar, but they are all very important.

Res+

Use this to add polygon resolution only when you have exhausted the ability of the current resolution to add sufficient detail to your sculpture.

Increase resolution

Increasing the resolution will effectively double the number of polygons the current object layer has. This allows for a layer to have much more detail at higher resolutions. You can view the resolution of a layer, in the Sculpt Tree, directly before the layer’s name. If it has just the name, then you will know that it is at its base resolution and has not been increased.

Resample

Resample: This presents you with a dialog that allows you to adjust the resolution of your model “up or down”, as you require.

Clear

It will clear all polygon information from the current layer. This is useful when you wish to keep the current layer’s name and resolution but not the voxels.

Smooth all

Smooth all: Performs smoothing of everything on the current sculpt layer. Will uniformly smooth (or relax) all of the faces of the currently selected object layer in the Sculpt Tree.

Edges relax (available on Surface mode)

Only working on Surface mode, this tool relax the open edges of the surface mesh (holes boundaries).

Multiresolution on Surface mode

This feature Works only in surface mode so you need to switch to the surface mode and you can see that new buttons have appeared in the toolbar. If we click one of them to 3DCoat offers us to open the multi-resolution panel. If we click yes then the multi-resolution panel will open also you can find this panel among the windows tabs.

UP Step UP with the multiresolution, and add the new subdivision layer if you are on the highest one.
DOWN Step DOWN with the multiresolution (if it exists).